Works on 22 Ryker Sport
Purchased this to test fit on my 22 Ryker Sport, even though it says it does not fit. Installation was a little more difficult that what I have read. I had to unbolt the lower shock support to gain more room to fit the block in. My clearance from the lower shock support to rear tire is 3/4" with no load on the suspension. Adjusted the spanner rings for the spring to where it felt the best for me and Test rode solo and two up with a rear case attached resulted in no issues with clearance and no longer bottoms out on the fender.

Lift kit
The install was relatively easy. Measured ride height before and after and gained about a two and a half inch raise. Will test with 2 up this weekend. Hopefully resolved bottoming out issue.

The part you didn't know you needed!
I ordered this part because of the added weight from the tour pak set up I added and riding two up. With all of this added weight, it causes the ryker to bottom out and cause damage to the rear wheel fender. The installation was super easy. It helps to use a floor jack and jack stand. Use the jack stand on the right side of the bike and the floor jack on the left side. This will let your ryker's rear wheel to lift off the ground while keeping your front wheels planted on the ground. Very happy with my purchase so far.

3 inch Se lift kit.
This kit is easy to install, and gives the ryker awesome amount of lift in the rear. Super happy with the add on.

Just what the ryker needs
Super easy to install now you can ride with a passenger without worries of a dent on the rear fender and the clearance of 3” is really what the ryker was missing