Plug N' Play Top Case Brake Light Flasher / Modulator Kit for the Can-Am Spyder F3 Limited (All Years) & RT Limited (2020+)

Can-Am Spyder F3 Limited / RT Limited Top Case Brake Light Flasher
If you'd like to increase your likelihood of being seen by other motorists while out on the open road, then our Top Case Brake Light Flasher from the team over at TricLED is for you. This little guy is 100% plug n' play and installs in just a few minutes. The flasher is compatible with all F3 Limited Models as well as all 2020 & newer RT Limited Models. Once installed, you'll go from a standard brake light to a modulating brake light that flashes 3 times every time you step on the brake pedal, to catch the attention of distracted motorists trailing behind you.

Simple Installation

1. Access the rear trunk and use a push pin removal tool to remove the two push pins securing the plastic panel that's housing the brake light.
2. Disconnect the factory brake light connector, add dielectric grease to each connector, and plug in the flasher to the corresponding connectors.
3. Test the functionality with your ignition on; once confirmed, re-install the body panel and push pins.